STUDY OF NONUNIFORM DISTRIBUTION OF FLOW IN HEAT EXCHANGERS

SEEMANT KUMAR BEDIA, RAM KUMAR VISHWAKARMA

Abstract


ABSTRACT:

It is researched that for uniform mass stream appropriation on cylinder side and perfect fitting stream on shell side, there is no distinction the cross-sectional mean temperature and adiabatic mean temperature. In any case, for non-uniform without reverse on cylinder side and perfect attachment stream on shell side, the two mean temperatures have same incentive at the cross-segment ξ=0. For non-uniform with reverse on cylinder side and perfect fitting stream on shell side, the temperature hop happens toward the start of the estimation area.


Keywords


HEAT EXCHANGERS, CROSSFLOW, SEGREGATED SOLVER, COUPLED SOLVER

Full Text:

PDF

References


REFERENCES

Wilfried Roetzel and Chakkrit Na Ranong,. 1999, “Consideration of maldistribution in heat exchangers using the hyperbolic dispersion model” Chemical Engineering and Processing 38, pp. 675–681.

Sahoo, R.K., and Wilfried Roetzel., 2002, “Hyperbolic axial dispersion model for heat exchangers” International Journal of Heat and Mass Transfer 45, pp 1261–1270.

Wilfried Roetzel , Chakkrit Na Ranong., 2000 “axial dispersion model for heat exchangers” Heat and Technology vol. 18.

Yimin Xuan, and Wilfried Roetzel., “Stationary and dynamic simulation of multipass shell and tube heat exchangers with the dispersion model for both fluids” Int. J. Heat Mass Transfer. Vol. 36, No. 17,4221A231,

Danckwerts, P.V., 1953, Continuous flow systems Distribution of Residence times Chemical Engineering science genie chimique Vol. 2.

Lalot, S., P. Florent , Langc, S.K., Bergles, A.E., 1999, “Flow maldistribution in heat exchangers “Applied Thermal Engineering 19, pp 847-863.

Prabhakara Rao Bobbili, Bengt Sunden, and. Das, S.K., 2006, “An experimental investigation of the port flow maldistribution in small and large plate package heat exchangers Applied Thermal Engineering 26, pp 1919–1926.

Zakro Stevanovic, Gradimir, Ilić., Nenad Radojković, Mića Vukić, Velimir Stefanović, Goran Vučković., 2001, “Design of shell and tube heat exchangers by using CFD technique- part one: thermo hydraulic calculation” Facta Universities Series: Mechanical Engineering Vol.1, No 8, pp. 1091 – 1105

Wilfried roetzel and Das, S.K., 1995 “Hyperbolic axial dispersion model: concept and its application to a plate heat exchanger” Int..J. Heat Mass Transfer. Vol. 38, No. 16, pp. 3062-3076.

Anindya Roy, and Das, S.K., 2001, “An analytical solution for a cyclic regenerator in the warm-up period in presence of an axially dispersive wave” Int. J. Therm. Sci. 40, pp.21–29.

Ping Yuan., 2003 “Effect of inlet flow maldistribution on the thermal performance of a three-fluid crossflow heat exchanger International” Journal of Heat and Mass Transfer 46, pp.3777–3787.

Srihari, N., Prabhakara Rao, B., Bengt Sunden, Das, S.K., 2005 “Transient response of plate heat exchangers considering effect of flow maldistribution” International Journal of Heat and Mass Transfer 48, pp. 3231–3243.


Refbacks

  • There are currently no refbacks.